Gonventional Brake Components
Brake Pedal and Brake Pedal Position Switch Adiustment
Pedal Height
' t .
Disconnect the brake Dedal Dosition switch
connector, loosen the brake pedal position switch
locknut (A), and back off the brake pedal position
switch {B) until it is no longer touching the brake
p e d a l .
Lift up the carpet and the insulator cutout (C).
Measure the pedal height (D) from the middle of
the right side cener of the pedal pad {E).
Standard Pedal Height
(with carpet removed): 179 mm (7 1/16 in.l
\
-
-
'-.-, tt'tll -
.
" ' ' - -
- _ ' ,
p;,','
19-6
5. Check the brake pedal free play.
3. Loosen the pushrod locknut {A), and screwthe
pushrod in or out with pliers until the standard
pedal height from the floor is reached. After
adjustment, tighten the locknut firmly. Do not
adjust the pedal height with the pushrod pushed in.
{1,5 kgf.m. 11 lblftl
Screw in the brake Dedal Dosition switch until its
plunger is fully pushed in (threaded end (A)
touching the pad (B) on the pedal arm). Then back
off the switch 1/4 turn to make 0.3 mm (0.01 in.) of
clearance between the threaded end and the Dad.
Tighten the locknut firmly.
NOTE: The brakes will drag if there is no clearance.
Connect the brake Dedal oosition switch connector.
Make sure that the brake lights go off when the
oedal is released.
4 .
0.3 mm (0.01 in.)
i:
\.-