Honda Accord 2008 Manual page 1859

07/11/02 09:40:27 61TA0000_200_0292
Frame
Subframe Replacement (cont'd)
Front Subframe Alignment
NOTE: Using the frame positioning guide pin, make the front suspension subframe alignment as the following
sequence.
1. Make the front suspension subframe (A) alignment.
–1 Lift the front suspension subframe up to the body, and loosely install the new subframe mounting bolts and
–2 Insert the alignment pin (C) into the alignment hole in the right rear of the subframe, and then align the
–3 Loosely tighten the subframe mounting bolt (D) until the lower insulator (E) contacts to the body at the right
–4 Insert the guide pin into the alignment hole in the left rear of the subframe, and then align the subframe with
–5 Loosely tighten the subframe mounting bolt (F) until the lower insulator contacts to the body at the left rear.
–6 Insert the guide pin into the alignment hole in the right rear of the subframe, and then tighten the mounting
–7 Insert the guide pin into the alignment hole in the left rear of the subframe, and then tighten the mounting bolt
–8 Tighten both front subframe mounting bolts (G) to the specified torque values.
–9 Tighten all of the bracket mounting bolts (H) to the specified torque values.
＊０２
2. Set the front suspension subframe middle mounting rubbers (I) on both sides, and tighten the rubber mounting
bolts (J) that secure the rubber to the body to the specified torque values. And tighten both subframe mounting
bolts (K) securing the subframe and the rubber to the specified torque values.
3. After reinstalling all removed parts, check and adjust the front wheel alignment (see page 18-5).
20-290
the brackets (B).
subframe with the body.
rear.
the body.
bolt to the specified torque values.
to the specified torque values.
I
K
J
H
A
E
Front
C B
070AG-SJAA10S
G
A
B
D
B
H
F
B
H
H
B
G
K
J
I