Honda Accord 2008 Manual page 1928

07/11/02 09:41:33 61TA0000_210_0064
Heater Unit/Core Replacement
SRS components are located in this area. Review the
SRS component locations (see page 24-19) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
1. Do the battery terminal disconnection procedure
(see page 22-89).
2. Disconnect the A/C line from the evaporator core
(see page 21-60).
3. When the engine is cool, drain the engine coolant
from the radiator (see page 10-6).
4. From under the hood, remove the clamp (A). Slide
the hose clamps (B) back. Disconnect the inlet
heater hose (C) and the outlet heater hose (D) from
the heater unit. Note the orientation of the hose.
Engine coolant will run out when the hoses are
disconnected; drain it into a clean drip pan. Be sure
not to let coolant spill on the electrical parts or the
painted surfaces. If any coolant spills, rinse it off
immediately.
＊０１
D
C
B
5. Remove the mounting nut from the heater unit.
Take care not to damage or bend the fuel lines or
brake lines, etc..
6. Remove the dashboard (see page 20-168).
7. Disconnect the connector (A). Remove the clips (B),
ducts (C), and the drain hose (D). Then remove the
mounting bolt, mounting nuts, and the blower-
heater unit (E).
A
A
D
B
ＴＡ０８Ａ００Ｇ２４１０００３１４６１ＫＢＡＴ８０
8 x 1.25 mm
12.3 N·m
(1.3 kgf·m, 9.0 lbf·ft)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
E
B
C
(cont'd)
21-63
＊０２
＊０３