Honda Accord 2008 Manual page 1929

07/11/02 09:41:34 61TA0000_210_0065
Heating/Air Conditioning
Heater Unit/Core Replacement (cont'd)
8. Remove the two screws, then remove the cover (A).
＊０４
9. Disconnect the connector (B) from the blower
motor. Remove the wire harness clip (C).
10. Disconnect these connectors (A): The mode control
motor, the power transistor, the evaporator
temperature sensor, the passenger's air mix
control motor (with climate control), and the
recirculation control motor. Remove the wire
harness clips (B).
＊０５
21-64
B
C
A
A
B
A
B
11. Disconnect the connector (A) from the air mix
control motor. Remove the wire harness clips (B),
the connector clip (C), and the wire harness (D).
D
C
A
12. Remove the self-tapping screws and the passenger's
heater duct (A). Remove the self-tapping screws
and the expansion valve cover (B). Remove the
self-tapping screw and the heater core cover (C).
Remove the self-tapping screws, the heater pipe
bracket (D), and the grommet (E), and carefully pull
out the heater core (F).
A
C
F
B
B
D
E
＊０６
＊０７