Honda Accord 2008 Manual page 1854

07/11/02 09:40:24 61TA0000_200_0287
3. Remove the screw securing the front door sill trim
(A) and the trunk lid opener/fuel fill door opener.
０２
Fastener Location
: Screw, 1
4. Remove the front door sill trim:
• 2-door (see step 4 on page 20-97)
• 4-door (see step 4 on page 20-99)
5. Remove the bolt, then remove the trunk lid opener/
fuel fill door opener (A) from the bolt (B).
０３
Fastener Location
: Bolt, 1
A
A
B
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
6. Disconnect the trunk lid opener/fuel fill door opener
cable (A), then remove the opener (B). Take care
not to kink the cable.
A
7. Install the opener in the reverse order of removal,
and note these items:
• Make sure the opener cable is connected
properly.
• Make sure the trunk lid and fuel fill door open
properly and lock securely.
• Fix at the original position in the outer end of
cable on the trunk lid opener/fuel fill door opener
securely. And check the trunk lid latch operation:
Make sure trunk lid latch, and fuel fill door latch
unlock when pulling, and pushing the trunk lid
opener/fuel fill door opener. If necessary, adjust
the position of the cable end.
• Before tightening the opener mounting rear bolt,
position the front door sill trim against the
opener certainly by screwing the trim onto the
opener.
０４
B
20-285