Honda Accord 2008 Manual page 1848

07/11/02 09:40:12 61TA0000_200_0281
Trunk Lid Opener Cable/Fuel Fill Door Opener Cable Replacement
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-21),
4-door (see page 24-19) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the body and the related
parts.
1. Remove these items:
• Rear seat cushion (see page 20-224)
• Rear seat side bolster, 4-door (see page 20-224)
• Front door sill trim, driver's side:
– 2-door (see page 20-97)
– 4-door (see page 20-99)
• Rear door sill trim, both sides, 4-door (see page
20-100)
• B-pillar lower trim, 4-door (see page 20-107)
• Rear side trim panel, 2-door (see page 20-118)
• Trunk side trim panel, left side (see page 20-123)
• Rear wheelhouse insulator (see step 10 on page
20-125)
• Fuel cap adapter (see page 20-254)
2. Pull the carpet back as needed.
3. Disconnect the trunk lid opener cable/fuel fill door
opener cable (A) from the trunk lid opener/fuel fill
door opener (B) (see page 20-284). Take care not to
kink the cable.
2-door
Fastener Locations
C : Clip, 1 D : Cushion tape, 1
4-door
Fastener Location
C : Clip, 1
4. Release the opener cable from the clip (C). 2-door:
Remove the cushion tape (D).
ＴＡ０８Ａ００Ｊ１８５７３５６０３３２ＫＢＡＴ２０
A
D
B
C
A
B
C
(cont'd)
20-279
＊０１
＊０２