Subaru IMPREZA GD 2007 Series Manual page 2957

asieps_tobira_IM_US.book 52 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1) Insert the reverse lock plunger.
2) Install the reverse check plug, spring, gasket,
and plug in order.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
(A) Plug
(B) Gasket
(C) Spring
(D) Reverse check plug
3) Install the spring and reverse check shaft to the
extension case.
NOTE:
Confirm that the end of the spring matches the hole
of the reverse check shaft and the cut out of the ex-
tension case.
(B)
(A)
(C)
(A) Reverse check shaft
(B) Spring
(C) Hole
(D) Cut out
Reverse Check System
4) Install the washer and snap ring.
(D)
(C)
(B)
(A)
5) Attach ST1 to the reverse check shaft. Install the
new oil seal, and push it in using ST2.
MT-00497
ST1 18671AA000 OIL SEAL GUIDE
ST2 18657AA010 INSTALLER
6) Insert the reverse check lever, and turn the re-
verse check shaft until the plunger is first pushed
in.
(B)
(A)
(D)
MT-00499
6MT-52
(B)
(A) Snap ring
(B) Washer
ST2
(A)
(A) Oil seal
(A)
(B)
(A) Plunger
(B) Reverse check shaft
(A)
MT-00494
ST1
MT-00500
MT-00501