Subaru IMPREZA GD 2007 Series Manual page 3117

asieps_tobira_IM_US.book 10 ページ ２０１２年１月１７日 火曜日 午後３時４８分
ABS
3. ABS Sequence Control
A: OPERATION
1) While the ABS sequence control is being per-
formed, the operation of the hydraulic unit can be
checked using the brake tester or pressure gauge
after the hydraulic unit solenoid valve operation.
2) ABS sequence control can be started by the
Subaru Select Monitor.
1. ABS SEQUENCE CONTROL WITH SUB-
ARU SELECT MONITOR
NOTE:
In the event of any trouble, sequence control will
not operate. In this case, diagnose the failure.
<Ref. to ABS(diag)-2, PROCEDURE, Basic Diag-
nostic Procedure.>
1) Connect the Subaru Select Monitor to data link
connector under the driver's side instrument panel
lower cover.
2) Turn the ignition switch to ON.
3) Run the Subaru Select Monitor.
4) Set the Subaru Select Monitor to {Brake Control}
mode.
5) When the {Function check sequence} is select-
ed, the ABS sequence control will start.
6) Execute the following operations when the mes-
sage {Press the brake pedal so that the brake ped-
al force is between 100 and 150 kgf} is displayed.
(1) When using a brake tester, press the brake
pedal pad with a force of 981 N (100 kgf, 221
lbf).
(2) When using a pressure gauge, press the
brake pedal so that the pressure gauge indi-
cates 3,432 kPa (35 kgf/cm
7) {Press the "YES" key} will be displayed. Press
the [YES] key.
8) The brake system being operated is displayed
on the Subaru Select Monitor.
ABS Sequence Control
2
, 498 psi).
ABS-10