Subaru IMPREZA GD 2007 Series Manual page 2751

asieps_tobira_IM_US.book 18 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
4. Release Bearing and Lever
A: REMOVAL
1. EXCEPT FOR STI MODEL
1) Remove the transmission assembly from vehicle
body.
<Ref. to 5MT-25, REMOVAL, Manual Transmis-
sion Assembly.>
2) Remove the two clips from the release lever and
remove the release bearing. (Non-turbo model)
CAUTION:
Be careful not to deform the clips.
3) Remove the release bearing from the release le-
ver. (Turbo model)
4) Remove the dust cover.
( A )
( B )
(A) Release lever
(B) Dust cover
5) Remove the lever spring from the pivot with a
screwdriver by accessing it through the clutch
housing release lever hole. Then remove the re-
lease lever.
( B )
(A) Release lever
(B) Screwdriver
2. STI MODEL
1) Remove the transmission assembly from vehicle
body.
<Ref. to 6MT-34, REMOVAL, Manual Transmis-
sion Assembly.>
2) Remove the release lever from the transmission.
Release Bearing and Lever
3) Using a flat tip screwdriver, remove the release
bearing from the clutch cover.
B: INSTALLATION
1. EXCEPT FOR STI MODEL
NOTE:
Apply the specified grease to lubricate the following
points before installation.
• Contact surface of lever and pivot
• Contact surface of lever and bearing
• Transmission main shaft spline (Use grease con-
taining molybdenum disulphide.)
1) Apply
CL-00023
No. 003603001) to the contact point of the re-
lease lever and operating cylinder.
2) While pushing the release lever to the pivot and
twisting it to both sides, fit the lever spring onto the
raised portion of the pivot. (Non-turbo model)
( A )
CL-00024
NOTE:
Observing from the main case hole, check that the
lever spring is installed securely.
3) Hook the release bearing to the release lever,
and fit the lever spring onto the raised portion of the
pivot. while pushing the release lever to the pivot
and twisting it to both sides (Turbo model)
NOTE:
Observing from the main case hole, check that the
lever spring is installed securely.
CL-18
(A) Release bearing
grease (KOPR-KOTE:
( A )
(A) Release lever
( A )
CL-00025
Part
CL-00026