Subaru IMPREZA GD 2007 Series Manual page 2801

asieps_tobira_IM_US.book 28 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CONTROL SYSTEMS
4) Install the washer and snap pin to range select
lever.
(D)
(C) (E)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
5) Insert the tip of inner cable into connector hole of
the select lever, and affix the outer cable end to the
bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
6) Move the select lever to the "N" range, then ad-
just the select cable position. <Ref. to CS-28, AD-
JUSTMENT, Select Cable.>
7) Install the front, center and rear exhaust pipes,
and the muffler. (SOHC model)
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H4SO)-7, INSTALLA-
TION, Center Exhaust Pipe.> <Ref. to EX(H4SO)-
8, INSTALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-9, INSTALLATION, Muffler.>
8) Install the center, rear exhaust pipes and the
muffler. (DOHC Turbo model)
<Ref. to EX(H4DOTC)-11, INSTALLATION, Center
Exhaust Pipe.> <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4DOTC)-17, INSTALLATION, Muffler.>
C: INSPECTION
Check the removed cable and replace if damaged,
rusty or having problems.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and
cracks.
4) Check the boot for damage, cracks and deterio-
ration.
5) Move the select lever from "P" to "1" range.
Check the existence of feel to contact the detents in
each range. If the detents cannot be felt or the po-
sition pointer is improperly aligned, adjust the ca-
ble.
Select Cable
(A)
(B)
CS-00036
CS-28
D: ADJUSTMENT
1) Set the vehicle on a lift.
2) Set the select lever to "N" range.
3) Lift up the vehicle.
4) Remove the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-9, REMOVAL, Muffler.>
• DOHC Turbo model
<Ref. to EX(H4DOTC)-15, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, REMOV-
AL, Muffler.>
5) Loosen the adjusting nuts on both sides.
(A) Adjusting nut A
(B) Adjusting nut B
6) Turn adjusting nut B until it lightly touches the
connector.
(B)
(A)
(D)
(E)
(A) Front side
(B) Select lever
(C) Connector
(D) Adjusting nut B
(E) Contact point
(F) Adjusting nut A
( B ) ( A )
CS-00040
(C)
(F)
CS-00041