Subaru IMPREZA GD 2007 Series Manual page 2766

asieps_tobira_IM_US.book 33 ページ ２０１２年１月１７日 火曜日 午後３時４８分
9) Tighten the push rod lock nut.
Tightening torque (Push rod lock nut):
T: 10 N·m (1.0 kgf-m, 7 ft-lb)
(A)
T
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
10) Depress and release the clutch pedal two or
three times to ensure that the clutch pedal and re-
lease lever operate smoothly. If the clutch pedal
and release lever do not operate smoothly, bleed
air from the clutch hydraulic system. <Ref. to CL-
28, Clutch Fluid Air Bleeding.>
11) Measure the clutch pedal full stroke length
again to ensure that it is within specifications. If it is
not within specifications, repeat adjustment proce-
dures again from the beginning.
Clutch pedal full stroke:
130 — 135 mm (5.12 — 5.31 in)
12) Push the release lever until the operating cylin-
der push rod retracts. Make sure that the clutch flu-
id level in the reservoir tank increases. If the clutch
fluid level increases, the hydraulic clutch is properly
adjusted; If the fluid level does not increase or the
push rod does not retract, replace the master cylin-
der with a new part. <Ref. to CL-24, Master Cylin-
der.>
(3)
(1) Push rod
(2) Release lever
(3) Operating cylinder
Clutch Pedal
13) Push the release lever until the operating cylin-
der push rod retracts. Check that the clutch fluid
level in the reservoir tank increases.
(B)
CL-00226
14) If the clutch fluid level increases, hydraulic
clutch play is correct.
15) If the clutch fluid level does not increase or
push rod does not retract, readjust the clutch pedal.
16) Check the fluid level using the scale on the out-
side of the reservoir tank. If the level is below "MIN",
fill fluid up to "MAX" level.
Recommended clutch fluid:
(2)
(1)
CL-00227
CL-33
(3)
(1) Push rod
(2) Release lever
(3) Operating cylinder
New FMVSS No. 116 DOT3 or DOT4 brake fluid
(A) MAX. level
(B) MIN. level
(C) Reservoir tank
CLUTCH SYSTEM
(2)
(1)
CL-00227
(C)
(A)
(B)
CL-00382