Subaru IMPREZA GD 2007 Series Manual page 3020

asieps_tobira_IM_US.book 115 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2. 3RD-4TH FORK ROD SELECTION
NOTE:
In the following conditions, perform the procedures
below.
• Main shaft replacement
• 3rd, and 3rd to 6th drive gear and bushing re-
placement
• 3rd, and 3rd to 6th synchro assembly replace-
ment
• 3rd-4th hub and sleeve assembly replacement
1) Insert the main shaft assembly into the adapter
plate.
2) Set the height gauge to the adapter plate. Lower
the height gauge indicator to the top surface of the
snap ring groove, and set to the zero point on the
upper side of the main rear bearing.
ST 18853AA000 HEIGHT GAUGE
(A) Roller bearing
NOTE:
• The height gauge will be set on the adapter plate
during the measurement. Use a scraper to remove
any gasket material remaining on the end face.
• During measurement, do not place the height
gauge in the shaded area shown in the figure.
Shifter Fork and Rod
MANUAL TRANSMISSION AND DIFFERENTIAL
3) Use a height gauge to measure "C1" and "C2" as
shown in the figure.
(A)
(A) 3rd drive gear
(B) 4th drive gear
MT-00706
MT-00583
6MT-115
C2
C1
(B)
(A)
MT-00707