Subaru IMPREZA GD 2007 Series Manual page 3261

asieps_tobira_IM_US.book 52 ページ ２０１２年１月１７日 火曜日 午後３時４８分
BRAKE
14.Brake Pedal
A: REMOVAL
1. MT MODEL
1) Remove the steering shaft.
2) Disconnect the connector (stop light switch etc)
from the pedal bracket.
3) Remove the clevis pin which secures the lever
and push rod.
4) Remove the nut which secures the clutch master
cylinder.
5) Remove the accelerator pedal.
6) Remove the bolt and nut which secures the ped-
al bracket.
2. AT MODEL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover from
instrument panel.
3) Remove the clevis pins which secure the brake
pedal to the brake booster operating rod. Also dis-
connect the stop light switch connector.
Brake Pedal
4) Remove the four bolts and four nuts which se-
cure brake pedal to pedal.
BR-00128 (1) Clevis pin
(2) Snap pin
(3) Operating rod
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
• If the cable clamp is damaged, replace it with
a new part.
• Be sure to cover outer cable end with boot.
• Always use a new clevis pin.
2) Adjust the clutch pedal. <Ref. to CL-31, AD-
JUSTMENT, Clutch Pedal.>
3) Check the brake pedal after installation. <Ref. to
BR-54, INSPECTION, Brake Pedal.>
C: DISASSEMBLY
1. MT MODEL
1) Remove the brake switch. <Ref. to BR-55, RE-
MOVAL, Stop Light Switch.>
2) Remove the clutch pedal. <Ref. to CL-30, DIS-
ASSEMBLY, Clutch Pedal.>
BR-52
(1)
(2)
(3)
BR-00140