Subaru IMPREZA GD 2007 Series Manual page 3430

asieps_tobira_IM_US.book 24 ページ ２０１２年１月１７日 火曜日 午後３時４８分
POWER ASSISTED SYSTEM (POWER STEERING)
13) Remove the clamp bolts securing the gearbox
to the crossmember, and remove the gearbox.
• Non-turbo model
(1) Clamp
• Turbo model
(1)
(1) Clamp
B: INSTALLATION
1) Insert the gearbox into crossmember, being
careful not to damage gearbox boot.
2) Tighten the gearbox to the crossmember bracket
via clamp with bolt, and tighten to the specified
torque.
Tightening torque:
60 N·m (6.1 kgf-m, 44.3 ft-lb)
• Non-turbo model
(1) Clamp
Steering Gearbox
• Turbo model
(1)
(1) Clamp
PS-00028
3) Connect the pipe D first to gearbox, then lower
pipe C.
Tightening torque:
15 N·m (1.5 kgf -m, 10.8 ft-lb)
PS-00787
(1) Pipe C
(2) Pipe D
4) Install the universal joint. <Ref. to PS-19, IN-
STALLATION, Universal Joint.>
5) Connect the tie-rod end and knuckle arm, and
tighten with castle nut.
Tightening torque (castle nut):
27 N·m (2.75 kgf-m, 19.9 ft-lb)
CAUTION:
When connecting, do not hit the cap at the bot-
(1)
tom of tie-rod end with hammer.
PS-00028
PS-24
(1)
(2)
(1)
PS-00787
PS-00027