Subaru IMPREZA GD 2007 Series Manual page 2860

asieps_tobira_IM_US.book 37 ページ ２０１２年１月１７日 火曜日 午後３時４８分
8. Vehicle Speed Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the front, center and rear exhaust pipes
and the muffler.
• Non-turbo model
<Ref. to EX(H4SO)-4, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-7, REMOVAL, Center
Exhaust Pipe.> <Ref. to EX(H4SO)-8, REMOVAL,
Rear Exhaust Pipe.> <Ref. to EX(H4SO)-9, RE-
MOVAL, Muffler.>
• Turbo model
<Ref. to EX(H4DOTC)-8, REMOVAL, Front Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-10, REMOV-
AL, Center Exhaust Pipe.> <Ref. to EX(H4DOTC)-
15, REMOVAL, Rear Exhaust Pipe.> <Ref. to
EX(H4DOTC)-17, REMOVAL, Muffler.>
4) Disconnect the connector from vehicle speed
sensor.
5) Turn the vehicle speed sensor to remove.
B: INSTALLATION
NOTE:
• Discard the vehicle speed sensor after removal,
and replace with a new sensor.
• Make sure that there is no foreign matter on the
sensor mounting.
• Align the tip end of the key with the key groove
on the end of speedometer shaft during installation.
1) Hand tighten the vehicle speed sensor.
2) Tighten the vehicle speed sensor using suitable
tools.
Tightening torque:
5.9 N·m (0.6 kgf-m, 4.3 ft-lb)
3) Connect the connector of the vehicle speed sen-
sor.
Vehicle Speed Sensor
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Install the front, center and rear exhaust pipes,
and the muffler.
• Non-turbo model
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H4SO)-7, INSTALLA-
TION, Center Exhaust Pipe.> <Ref. to EX(H4SO)-
8, INSTALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-9, INSTALLATION, Muffler.>
• Turbo model
<Ref. to EX(H4DOTC)-8, INSTALLATION, Front
Exhaust Pipe.> <Ref. to EX(H4DOTC)-11, IN-
STALLATION, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-15, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-17, INSTALLATION,
Muffler.>
5) Lower the vehicle.
6) Connect the ground cable to battery.
C: INSPECTION
Because the vehicle speed sensor cannot be in-
spected by itself, check whether the speedometer
is operating properly. If it is not operating properly,
check the combination meter system. <Ref. to IDI-
3, INSPECTION, Combination Meter System.>
MT-00113
5MT-37