Subaru IMPREZA GD 2007 Series Manual page 2621

asieps_tobira_IM_US.book 114 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
23) 2-4 Brake retaining plate selection (turbo model)
(1) Install the pressure plate, drive plate, driven
plate, retaining plate and snap ring.
(2) Install a new 2-4 brake oil seal to the trans-
mission case.
(3) After all 2-4 brake component parts have
been installed, blow in air intermittently and
confirm the operation of the brake.
(4) Check the clearance between the retaining
plate and snap ring.
NOTE:
If the drive plate is not being replaced, do not ad-
just.
If the value exceeds the service limits, replace the
drive plate with a new part and make adjustment so
that the clearance is within the standard.
AT Main Case
Initial standard:
0.8 — 1.2 mm (0.031 — 0.047 in)
Limit thickness:
1.5 mm (0.059 in)
AT-00254
Part No.
31567AA991
31567AB001
31567AB011
31567AB021
31567AB031
31567AB041
24) 2-4 Brake retaining plate selection (non-turbo
AT-00284
model)
(1) Place the dish plate, driven plate, drive plate
and retaining plate neatly in this order on sur-
face table.
(2) Set the micro gauge to clutch, and read its
scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
(3) Scale and record the weight Z of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
AT-00290
load as a flat board to be put on retaining plate.
• Use a flat board weighing less than 10.2 kg (22.5 lb).
(4) Put the flat board on retaining plate.
4AT-114
AT-00292
Retaining plate
Thickness mm (in)
5.6 (0.220)
5.8 (0.228)
6.0 (0.236)
6.2 (0.244)
6.4 (0.252)
6.6 (0.260)
AT-01720