Front Brake Pad - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分

2. Front Brake Pad

A: REMOVAL
1. 15-INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift up the vehicle, and remove the front wheels.
4) Remove the lower caliper bolts.
5) Raise the caliper body and support it.
NOTE:
Do not disconnect the brake hose from the caliper
body.
6) Remove the pad.
NOTE:
If the brake pad is difficult to remove, proceed as
follows:
(1) Remove the caliper body from support.
(2) Remove the support.
(3) Place the support between wooden blocks
in the vise.
(1) Support
(2) Wooden block
Front Brake Pad
BR-00012
(1)
(2)
BR-00013
BR-17
(4) Attach a rod of 12 mm (0.47 in) diameter or
less to the shaded area of the brake pad, and
strike the rod with a hammer to drive brake pad
out.
2. 16-INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift up the vehicle, and remove the front wheels.
4) Remove the M clip.
(1) M clip
5) Remove the pad pin, then remove the cross
spring.
(2)
(1) Pad pin
(2) Cross spring
BRAKE
BR-00014
(1)
BR-00288
(1)
BR-00289