Subaru IMPREZA GD 2007 Series Manual page 3245

asieps_tobira_IM_US.book 36 ページ ２０１２年１月１７日 火曜日 午後３時４８分
BRAKE
C: DISASSEMBLY
1. 14-INCH TYPE
1) Remove the boot ring.
(1)
(1) Boot ring
2) Remove the piston boot.
3) Place a wooden block in the caliper body as
shown in the figure to prevent the piston from jump-
ing out and being damaged.
4) Gradually apply compressed air via the brake
hose installation hole to push the piston out.
(1) Place a wooden block of 30 mm (1.18 in) width.
Rear Disc Brake Assembly
BR-00040
BR-00041
(1)
BR-00042
BR-36
5) Remove the piston seal from caliper body cylin-
der.
CAUTION:
Do not damage the cylinder and piston seal
groove.
6) Remove the lock pin sleeve and boot from cali-
per body.
7) Remove the guide pin boot.
2. 15-INCH TYPE
1) Remove the boot ring.
(1) Boot ring
2) Remove the piston boot.
3) Place a wooden block in the caliper body as
shown in the figure to prevent the piston from jump-
ing out and being damaged.
BR-00043
(1)
BR-00316
BR-00317