Subaru IMPREZA GD 2007 Series Manual page 2608

asieps_tobira_IM_US.book 101 ページ ２０１２年１月１７日 火曜日 午後３時４８分
• Toe contact (inside contact)
Check item: Teeth contact area is too small.
Contact pattern
Corrective action: Reduce thickness of the pinion
height adjusting washer according to the proce-
dures for moving the drive pinion away from the
driven gear side.
Drive Pinion Shaft Assembly
• Heel contact (outside end contact)
Check item: Teeth contact area is too small.
Contact pattern
AT-00210
Corrective action: Increase thickness of pinion
height adjusting washer according to the proce-
dures for moving the drive pinion closer to the driv-
en gear.
AT-00213
6) If tooth contact is correct, mark the retainer posi-
tion and loosen it. After fitting a new O-ring and oil
seal, screw in the retainer to the marked position.
Tighten the lock plate with specified torque.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
4AT-101
AUTOMATIC TRANSMISSION
(A)
(A) Lock plate
AT-00211
AT-00212
AT-00214