Subaru IMPREZA GD 2007 Series Manual page 2959

asieps_tobira_IM_US.book 54 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
15.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-34, REMOVAL,
Manual Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-39, Preparation for Overhaul.>
3) Remove the extension case. <Ref. to 6MT-44,
REMOVAL, Extension Case.>
4) Remove the transfer drive gear.
B: INSTALLATION
1) Install the transfer drive gear.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
2) When the ball bearing, transfer drive gear or
snap ring are replaced, select an appropriate thrust
washer for the transfer drive gear. <Ref. to 6MT-45,
ASSEMBLY, Extension Case.>
3) Install the extension case. <Ref. to 6MT-44, IN-
STALLATION, Extension Case.>
4) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
Transfer Drive Gear
C: DISASSEMBLY
1) Remove the snap ring.
2) Remove the bearing using the ST.
ST 499877000
NOTE:
Do not reuse the ball bearing.
MT-00505
D: ASSEMBLY
1) Using the ST, install the ball bearing.
ST1 499247400 INSTALLER
ST2 398497701
MT-00505
2) Install the snap ring.
6MT-54
MT-00506
RACE 4-5 INSTALLER
ST
MT-00507
SEAT
ST2
ST1
MT-00508
MT-00506