Subaru IMPREZA GD 2007 Series Manual page 3247

asieps_tobira_IM_US.book 38 ページ ２０１２年１月１７日 火曜日 午後３時４８分
BRAKE
6) Attach the piston boot to the caliper body, and
attach the boot ring.
(1)
(2)
(1) Piston boot
(2) Boot ring
(3) Piston seal
(4) Caliper body
7) Apply a coat of specified grease to the guide pin,
outer surface, sleeve outer surface, cylinder inner
surface, and boot grooves.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
(1)
(1) Pin boot
(2) Lock pin or guide pin
(3) Grease applied area
8) Insert the guide pin boot to the support.
9) Install the lock pin boot to the support, and then
insert the lock pin sleeve into the specified position.
2. 15-INCH TYPE
1) Clean the inside of the caliper body using brake fluid.
2) Apply a coat of brake fluid to piston seal and in-
stall piston seal in the groove on caliper body.
3) Apply a coat of brake fluid to the inner surface of
cylinder and the entire outer surface of the piston.
4) Apply a coat of specified grease to the boot and
fit to the groove on the piston.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
5) Insert the piston into cylinder.
CAUTION:
Do not force the piston into cylinder.
Rear Disc Brake Assembly
(3) (4)
BR-00029
: (3)
(2)
BR-00030
BR-38
6) Attach the piston boot to the caliper body, and
attach the boot ring.
(3)
(1) Piston
(2) Piston boot
(3) Piston seal
(4) Boot ring
3. 17-INCH TYPE
1) Clean the inside of the caliper body using brake fluid.
2) Apply a coat of brake fluid to the piston seal and
install the piston seal in the groove of the caliper
body.
3) Apply a coat of brake fluid to the inner surface
and the entire outer surface of the cylinder.
4) Apply a coat of specified grease to the boot and
fit to the groove on the piston.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
5) Insert the piston into the cylinder.
CAUTION:
Do not force the piston into cylinder.
6) Position the boot in the grooves on piston and
cylinder.
(1)
(1) Piston seal
(2) Piston boot
(3) Piston
E: INSPECTION
1) Repair or replace the faulty parts.
2) Check the caliper body and piston for uneven
wear, damage or rust.
3) Check the rubber parts for damage or deterioration.
(1)
(2)
(4)
BR-00308
(2)
(3)
BR-00309