Subaru IMPREZA GD 2007 Series Manual page 2610

asieps_tobira_IM_US.book 103 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6) Install new seal pipe to converter case.
(A) Seal pipe
7) Install the converter case to the transmission
case. <Ref. to 4AT-88, INSTALLATION, Converter
Case.>
8) Insert the inhibitor switch and transmission con-
nector to the stay.
(B)
(A) Transmission harness
(B) Inhibitor switch harness
9) Install the oil cooler pipe. <Ref. to 4AT-66, IN-
STALLATION, ATF Cooler Pipe and Hose.>
10) Install the oil charge pipe together with an O-
ring. <Ref. to 4AT-68, INSTALLATION, Oil Charge
Pipe.>
11) Insert the input shaft, and check the amount of
protrusion.
NOTE:
Turn the input shaft lightly by hand while inserting.
Normal protrusion amount A:
50 — 55 mm (1.97 — 2.17 in)
A
Front Differential Assembly
12) Install the torque converter clutch assembly.
<Ref. to 4AT-69, INSTALLATION, Torque Convert-
er Clutch Assembly.>
13) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-39, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove the taper roller bearing using the ST
and a press.
AT-00176
ST 498077000
(A)
2) Secure the case in a vise, remove the hypoid
driven gear tightening bolts, and then separate the
hypoid driven gear into case (RH) and case (LH).
AT-01351
AT-02384
4AT-103
AUTOMATIC TRANSMISSION
REMOVER
(C)
(A) Hypoid driven gear
(B) Differential case (RH)
(C) Differential case (LH)
AT-00216
(A)
(B)
AT-00217