Subaru IMPREZA GD 2007 Series Manual page 2983

asieps_tobira_IM_US.book 78 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
25) Using the ST, install the 6th bushing.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
26) Make sure that the 6th drive gear can be turned
smoothly by hand. If it does not turn smoothly, re-
assemble.
27) Using the ST, install the inner race of the inner
bearing.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
28) Using the ST, install the retainer and inner race
of the outer bearing.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
Main Shaft Assembly
NOTE:
• Confirm that the retainer is installed in the proper
direction.
• Push in until there is no backlash on the retainer,
or the bearing turns smoothly by hand.
ST1
ST2
MT-00577
ST1
29) Make sure that the taper roller bearing turns
smoothly by hand. If it does not rotate smoothly, re-
place the taper roller bearing as a set, and reas-
semble.
30) Attach the lock washer and a new lock nut.
31) Set the main shaft assembly to the ST, and
ST2
tighten the lock nut.
MT-00578
ST1 18665AA000 HOLDER
ST2 18664AA000 BASE
Tightening torque:
392 N·m (40.0 kgf-m, 289 ft-lb)
6MT-78
ST1
(B)
(A)
ST2
(A) Retainer
(B) Outer bearing inner race
ST2
ST1
(A)
MT-00579
MT-00556