Subaru IMPREZA GD 2007 Series Manual page 3019

asieps_tobira_IM_US.book 114 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
(2) Set the height gauge indicator upside down.
(A)
(A) Indicator
(3) Shift the 1st-2nd sleeve to the 2nd driven
gear side, push up on the stopper, and measure
"B2".
(A) 2nd driven gear
(B) 1st-2nd sleeve
NOTE:
• Set the height gauge indicator near the measure-
ment target, and lock dial (1) as shown in the figure.
Turn dial (2), and set the indicator to the 2nd side
end surface of the sleeve.
• The measurement is to be performed with two
persons, while holding the sleeve straight.
• Turn approximately 72° at a time, and measure
the sleeve in 5 locations. Round off the two highest
and two lowest measurement values. The remain-
ing center value is used as the measurement value.
Shifter Fork and Rod
Calculation: T = (B1 + B2) / 2
MT-00703
NOTE:
Attach the indicator upside down in comparison to
the setting procedures for the zero point. Add "d1"
[Value: 55 mm (2.17 in)] from the figure below to
"B2", and measure "B2".
(A)
(B)
MT-00704
(2)
(1)
MT-00585
6MT-114
(4) According to both of the measurements, cal-
culate the neutral position of the 1st-2nd sleeve.
From the following calculation, select a fork rod
which matches the calculated value.
T: 1st-2nd sleeve center position
B1: Height from the adapter plate end to the
sleeve end, when shifted to 1st gear
B2: Measured height from the adapter plate end
to the sleeve end, when shifted to 2nd gear: +55
mm (2.17 in)
d1
T mm (in)
62.93 — 63.23
(2.4776 — 2.4894)
63.23 — 63.53
32801AA131 (none)
(2.4894 — 2.5012)
63.53 — 63.83
(2.5012 — 2.5130)
MT-00705
Lot No. (marking)
32801AA111 (1)
32801AA141 (2)