Subaru IMPREZA GD 2007 Series Manual page 2750

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3. Flywheel
A: REMOVAL
1) Remove the transmission assembly.
5MT:
<Ref. to 5MT-25, REMOVAL, Manual Transmis-
sion Assembly.>
6MT:
<Ref. to 6MT-34, REMOVAL, Manual Transmis-
sion Assembly.>
2) Remove the clutch cover and clutch disc. <Ref.
to CL-14, REMOVAL, Clutch Disc and Cover.>
3) Using the ST, remove the flywheel.
ST 498497100 CRANKSHAFT STOPPER
( A )
(A) Flywheel
B: INSTALLATION
1) Install the flywheel and ST.
ST 498497100 CRANKSHAFT STOPPER
S T
2) Tighten the flywheel mounting bolts to the spec-
ified torque.
NOTE:
Tighten the flywheel attachment bolts gradually.
Each bolt should be tightened to the specified
torque in crisscross order.
Flywheel
Tightening torque:
Except for STI model
STI model
3) Install the clutch disc and cover. <Ref. to CL-14,
INSTALLATION, Clutch Disc and Cover.>
4) Install the transmission assembly.
5MT:
<Ref. to 5MT-28, INSTALLATION, Manual Trans-
mission Assembly.>
6MT:
<Ref. to 6MT-36, INSTALLATION, Manual Trans-
S T
mission Assembly.>
CL-00019
C: INSPECTION
CAUTION:
Because this bearing is grease-sealed and is a
non-lubrication type, do not wash with gasoline
or solvents.
1) If there is damage or defectiveness in the facing
sliding surface or ring gear, replace the flywheel.
CL-00020
2) Smoothness of rotation
Rotate the ball bearing while applying pressure in
the thrust direction.
3) If noise or excessive play is noted, replace the
flywheel.
CL-17
72 N·m (7.3 kgf-m, 52.8 ft-lb)
75 N·m (7.6 kgf-m, 55.3 ft-lb)
( 1 )
( 5 )
( 7 )
( 3 )
( 4 )
( 8 )
( 6 )
( 2 )
( A )
(A) Flywheel
(B) Ring gear
CLUTCH SYSTEM
CL-00021
( B )
CL-00022