Subaru IMPREZA GD 2007 Series Manual page 2709

asieps_tobira_IM_US.book 70 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Step
1 CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
1) Turn the ignition switch to OFF.
2) Disconnect the connectors from TCM and
transmission.
3) Measure the resistance of harness between
TCM connector and transmission connector.
Connector & terminal
(B54) No. 4 — (B11) No. 3:
2 CHECK HARNESS CONNECTOR BETWEEN
TCM AND CHASSIS GROUND.
Measure the resistance of harness between
TCM connector and chassis ground.
Connector & terminal
(B54) No. 4 — Chassis ground:
3 CHECK 2-4 BRAKE DUTY SOLENOID.
Measure the resistance between transmission
connector terminals.
Connector & terminal
(T4) No. 3 — No. 20:
4 CHECK OUTPUT SIGNAL FROM TCM US-
ING SUBARU SELECT MONITOR.
1) Connect all connectors.
2) Connect the Subaru Select Monitor to the
data link connector.
3) Start the engine, and run the Subaru Select
Monitor.
4) Warm-up the transmission until the ATF
temperature exceeds approximately 80°C
(176°F).
NOTE:
If the ambient temperature falls below 0°C
(32°F), drive the vehicle until the ATF reaches
its operating temperature.
5) Stop the engine and turn the ignition switch
to ON (with engine OFF).
6) Move the select lever to "N".
7) Read the data of 2-4 brake duty solenoid
using the Subaru Select Monitor.
• 2-4 brake duty solenoid is indicated in "%".
5 CHECK OUTPUT SIGNAL FROM TCM US-
ING SUBARU SELECT MONITOR.
1) Move the select lever to "2" range.
2) Turn the hold switch to ON.
Check
Is resistance less than 1 Ω?
Is the resistance 1 MΩ or
more?
Is the resistance 2.0 — 6.0 Ω? Go to step 4.
Is the measured value 100%?
Is the measured value 0%?
4AT(D)(diag)-70
Yes No
Go to step 2. Repair the open
circuit of harness
between TCM and
transmission con-
nector.
Go to step 3. Repair the short
circuit of harness
between TCM and
transmission con-
nector.
Go to step 6.
Go to step 5.
Repair the poor
contact.
Even if the ATF Repair the poor
temperature warn- contact.
ing light blinks, the
circuit is in normal
condition at this
time. A temporary
poor contact of
connector or har-
ness may be the
cause. Repair the
harness or con-
nector in TCM and
transmission.