Subaru IMPREZA GD 2007 Series Manual page 2638

asieps_tobira_IM_US.book 131 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2) Insert the range select lever being careful not to
damage the oil seal lip area, then tighten the bolt.
Tightening torque:
6 N·m (0.6 kgf-m, 4.3 ft-lb)
3) Install the manual plate and parking rod.
(A) Bolt
(B) Range select lever
(C) Manual plate
(D) Parking rod
4) Insert the spring pin to the manual plate.
5) Install the oil pan and the control valve assem-
bly. <Ref. to 4AT-60, INSTALLATION, Control
Valve Body.>
6) Turn over the transmission case to its original
position.
7) Install the pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
8) Install and adjust the inhibitor switch. <Ref. to
4AT-47, Inhibitor Switch.>
Transmission Control Device
9) Insert the inhibitor switch and transmission con-
nector to the stay.
AT-00308
10) Install the air breather hose. <Ref. to 4AT-67,
INSTALLATION, Air Breather Hose.>
11) Insert the input shaft, and check the amount of
protrusion.
NOTE:
Turn the input shaft lightly by hand while inserting.
Normal protrusion amount A:
50 — 55 mm (1.97 — 2.17 in)
AT-00306
12) Install the torque converter clutch assembly.
<Ref. to 4AT-69, INSTALLATION, Torque Convert-
er Clutch Assembly.>
13) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-39, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
AT-00305
Make sure the manual lever and detent spring are
not worn or otherwise damaged.
4AT-131
AUTOMATIC TRANSMISSION
(B)
(A)
(A) Transmission harness
(B) Inhibitor switch harness
A
AT-01351
AT-02384