Subaru IMPREZA GD 2007 Series Manual page 2807

asieps_tobira_IM_US.book 34 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CONTROL SYSTEMS
13) Extract the spring pin and remove the joint.
(B)
(A) Joint
(B) Spring pin
14) Lower the vehicle.
15) Remove the gear shift lever.
2. 6MT
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Remove the gear shift knob.
4) Remove the console box front. <Ref. to EI-46,
REMOVAL, Console Box.>
5) Remove the boot plate from the vehicle body.
6) Lift up the vehicle.
7) Remove the under cover.
8) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H4DOTC)-15, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, REMOV-
AL, Muffler.>
9) Remove the crossmember. <Ref. to 6MT-32,
REMOVAL, Transmission Mounting System.>
MT Gear Shift Lever
(A)
CS-00053
CS-00054
CS-00219
CS-34
10) Remove the snap pin and washer, and remove
the reverse check cable from the reverse check le-
ver.
(B)
(A) Snap pin
(B) Washer
(C) Reverse check cable
11) Move the transmission to the right side of the
vehicle, and remove the joint COMPL, stay bolts
and reverse check cable.
NOTE:
If the transmission is not moved aside, the joint
COMPL and stay bolts may contact the body and
cause damage.
(C)
(A)
(B)
(A) Joint COMPL bolt
(B) Stay bolt
(C) Reverse check cable
12) Remove the cushion rubber from the vehicle
body.
13) Lower the vehicle.
14) Remove the gear shift lever.
(A)
(C)
CS-00220
CS-00221
CS-00222