Subaru IMPREZA GD 2007 Series Manual page 3321

asieps_tobira_IM_US.book 55 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7. Rear Differential Member
A: REMOVAL
When removing the differential front member, use
the removal procedure for rear differential. <Ref. to
DI-23, REMOVAL, Rear Differential.>
B: INSTALLATION
1) Position the differential front member with the
vehicle body by passing the member under the
parking brake cable and securing it to rear differen-
tial.
NOTE:
When installing the differential front member, be
careful of the order for installation of the stoppers.
2) Insert the DOJ of the rear drive shaft into the rear
differential. <Ref. to DI-53, REPLACEMENT, Rear
Differential Side Oil Seal.>
NOTE:
Before inserting, replace the differential side oil
seal with a new part.
ST 28099PA090 OIL SEAL PROTECTOR
3) Hereafter, install in the reverse order of removal.
C: INSPECTION
1) Check the rear differential member for damage,
bend and corrosion.
If damage, bend or corrosion is excessive, replace
the rear differential member.
2) Check the bushings of the rear differential mem-
ber for cracking, hardening and damage.
If cracking, hardening or damage is excessive, re-
place rear differential member.
Rear Differential Member
DI-00058
ST
DI-00060
DI-55
DIFFERENTIALS