Subaru IMPREZA GD 2007 Series Manual page 2546

asieps_tobira_IM_US.book 39 ページ ２０１２年１月１７日 火曜日 午後３時４８分
NOTE:
Place cloth between the tire lever or bar and the
transmission in order to avoid damaging the trans-
mission side retainer.
(2) Hold the transmission side joint of the front
drive shaft by hand and extract the housing
from the transmission while pressing the hous-
ing outward, so as not to stretch the boot.
28) Remove the bolts which hold the clutch hous-
ing cover.
29) Remove the bolts which hold the lower side of
transmission to the engine.
30) Place a transmission jack below the transmis-
sion.
NOTE:
Make sure that the support plates of transmission
jack do not touch the oil pan.
31) Remove the transmission rear crossmember
from the vehicle.
32) While lowering the transmission jack gradually,
fully retract the engine support, and then tilt the en-
gine rearward.
Automatic Transmission Assembly
33) Remove the transmission.
NOTE:
Remove the transmission and torque converter as
a single unit from engine.
34) Remove the rear cushion rubber from the
transmission assembly.
B: INSTALLATION
1) Replace the differential side oil seal with a new
part. <Ref. to 4AT-46, REPLACEMENT, Differen-
tial Side Retainer Oil Seal.>
AT-00108
NOTE:
When a new oil seal has been installed, replace-
ment is not required.
2) Install the rear cushion rubber to the transmis-
sion assembly.
Tightening torque:
3) Attach the ST to the converter case.
ST 498277200
AT-03697
4) Install the transmission onto the engine.
4AT-39
AUTOMATIC TRANSMISSION
39 N·m (4.0 kgf-m, 29 ft-lb)
STOPPER SET
(1) Lift up the transmission gradually using
transmission jack.
AT-00109
ST
AT-00103
AT-00109