Subaru IMPREZA GD 2007 Series Manual page 2875

asieps_tobira_IM_US.book 52 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
6) With brackets and clips as shown in the figure,
tighten the 17 bolts.
NOTE:
• Insert the bolts from the bottom and tighten the
nuts at the top.
• Put the cases together so that the drive pinion
shim and input shaft holder shims are not caught in
between.
• Check that the speedometer gears are mating
correctly.
Tightening torque:
8 mm bolt
25 N·m (2.5 kgf-m, 18.4 ft-lb)
10 mm bolt
39 N·m (4.0 kgf-m, 28.9 ft-lb)
(9) (5)
(13)
(1)
(2)
(15)
(14)
(10)
(6)
7) Tighten the ball bearing mounting bolts.
Tightening torque:
30 N·m (3.1 kgf-m, 22.1 ft-lb)
Transmission Case
(16)
(17)
(7)
(11)
(3)
(4)
(8) (12)
MT-00172
MT-01514
5MT-52
8) Perform backlash adjustment of the hypoid gear
and preload measurement of the roller bearing:
NOTE:
Support the drive pinion shaft assembly with the
ST.
ST 498427100 STOPPER
ST
9) Place the transmission with the left side of case
facing downward, and put ST1 on bearing cup.
10) Screw the retainer assembly from the bottom
into left case using ST2. Fit the ST3 on transmis-
sion main shaft. Shift the gear into 4th or 5th, and
turn the shaft several times. Screw in the retainer
while rotating the ST3 until a slight resistance is felt
on ST2.
This is the contact point of the hypoid gear and the
drive pinion shaft. Repeat the above sequence sev-
eral times to ensure the contact point.
ST1 399780104 WEIGHT
ST2 18630AA010 WRENCH COMPL RETAIN-
ER
ST3 499927100 HANDLE
ST1
ST2
MT-01516
ST3
MT-00175