Subaru IMPREZA GD 2007 Series Manual page 2758

asieps_tobira_IM_US.book 25 ページ ２０１２年１月１７日 火曜日 午後３時４８分
C: DISASSEMBLY
1) Remove the straight pin and reservoir tank.
(A)
(A) Reservoir tank
(B) Straight pin
2) Remove the oil seal.
(B)
(A) Oil seal
(B) Master cylinder
3) Move the seat backwards.
(B)
(A) Seat
(B) Master cylinder
4) Remove the piston stop ring.
CAUTION:
When removing the piston stop ring, be careful
to prevent the rod, washer, piston and return
spring from coming out.
5) Remove the clutch damper.
Master Cylinder
(B)
CL-00046
(A)
CL-00047
(A)
CL-00513
CL-25
D: ASSEMBLY
1) Install the clutch damper.
Tightening torque:
46.6 N·m (4.75 kgf-m, 34.4 ft-lb)
2) Apply a coat of grease to the contact surfaces of
the push rod and piston before installation.
Grease:
SILICONE GREASE G-40M (Part No.
004404003)
3) Assemble in the reverse order of disassembly.
Tightening torque:
10 N·m (1.0 kgf-m, 7 ft-lb)
E: INSPECTION
If any damage, deformation, wear, swelling, rust or
other faults are found on the cylinder, piston, push
rod, reservoir tank, return spring, gasket, clutch
damper, seat or hose, replace the faulty part.
(C)
(B)
(A)
(F)
(A) Master cylinder body
(B) Return spring
(C) Piston
(D) Piston stop ring
(E) Push rod ASSY
(F) Clutch damper
(G) Seat
CLUTCH SYSTEM
CL-00515
(G)
(D)
(E)
CL-00517