Subaru IMPREZA GD 2007 Series Manual page 2573

asieps_tobira_IM_US.book 66 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the oil cooler inlet and outlet pipes with
new washers.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
T2: 40 N·m (4.1 kgf-m, 30 ft-lb)
T3: 45 N·m (4.16 kgf-m, 33 ft-lb)
T1
2) Install the ATF cooler pipe to frame.
3) Connect the ATF cooler hose to the pipe on the
transmission side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent or twisted.
ATF Cooler Pipe and Hose
• Insert the hose to the specified position.
4) Connect the ATF cooler hose to the pipe on the
radiator side.
T2
NOTE:
• Install so that the hose is not folded over, exces-
sively bent or twisted.
T3
• Insert the hose to the specified position.
AT-03826
5) Install the under cover.
6) Install the battery and washer tank.
7) Fill ATF. <Ref. to 4AT-28, Automatic Transmis-
sion Fluid.>
NOTE:
Make sure there are no ATF leaks in joints between
the transmission, radiator, pipes, and hoses.
C: INSPECTION
Repair or replace any faulty hoses, pipes, clamps,
and washers found in the inspection below.
1) Check for ATF leaks in joints between the trans-
AT-00456
mission, radiator, pipes, and hoses.
2) Check the clamp for deformation.
3) Lightly bend the hose and check for cracks in the
surface or other damages.
4) Pinch the hose with your fingers and check for
poor elasticity. Also check for poor elasticity in the
parts where the clamp was installed by pressing
with your fingernail.
5) Check for peeling, cracks, and deformation at
the tip of the hose.
4AT-66
AT-01333
AT-01345