Subaru IMPREZA GD 2007 Series Manual page 3353

asieps_tobira_IM_US.book 29 ページ ２０１２年１月１７日 火曜日 午後３時４８分
D: ASSEMBLY
NOTE:
When the hub is removed from the housing, re-
place the bearing set and oil seal.
1) Using the ST, press the new hub bolt into place.
NOTE:
• Make sure the hub bolt contacts the hub.
• Use the 12 mm (0.47 in) hole in the ST to prevent
the hub bolt from tilting during installation.
ST 927080000 HUB STAND
(Except for STI model)
ST 28099PA080 HUB STAND (STI model)
2) Remove the foreign particles (dust, rust, etc.)
from the mating surfaces of hub tone wheel, and in-
stall the tone wheel to hub.
NOTE:
• Make sure the tone wheel contacts the hub.
• Be careful not to damage the tone wheel teeth.
(1)
(1) Tone wheel
3) Clean the housing interior completely. Using
ST1 and ST2, press the bearing into the housing.
ST1 927430000 HOUSING STAND
(Except for STI model)
ST1 28099PA060 HOUSING STAND
(STI model)
ST2 927440000 BEARING PULLER
(Except for STI model)
ST2 927100000 BEARING PULLER
(STI model)
Rear Axle
NOTE:
Be careful not to remove the plastic lock from the
inner race when installing the bearings.
4) Using snap ring pliers, securely install the snap
ring.
ST
DS-00055
5) Using the ST1 and ST2, press the outer oil seal
unit until it comes in contact with snap ring.
ST1 927430000
ST1 28099PA060 HOUSING STAND
ST2 927460000
ST2 28099PA070 OIL SEAL INSTALLER
DS-00093
6) Invert both ST1 and housing (upside down).
DS-29
DRIVE SHAFT SYSTEM
ST2
ST1
(1)
(1) Snap ring pliers
HOUSING STAND
(Except for STI model)
(STI model)
OIL SEAL INSTALLER
(Except for STI model)
(STI model)
ST2
(1)
ST1
(1) Snap ring
DS-00094
DS-00095
DS-00096