Subaru IMPREZA GD 2007 Series Manual page 3465

asieps_tobira_IM_US.book 59 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7. Oil Pump
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the pulley belt cover.
3) Loosen the belt tension securing bolt and gener-
ator securing bolt, then remove the power steering
pump V-belt.
4) Disconnect the connector from power steering
pump switch.
5) Disconnect pipe C and suction hose from oil
pump.
CAUTION:
• Do not allow fluid to come into contact with
the pulley belt.
• To prevent foreign matter from entering the
hose and pipe, cover the open ends of them
with clean cloth.
(2)
(1) Suction hose
(2) Pipe C
6) Remove the installation bolt of the power steer-
ing pump bracket.
Oil Pump
POWER ASSISTED SYSTEM (POWER STEERING)
7) Place the oil pump bracket in a vise, and remove
the two bolts from the front side of the oil pump.
CAUTION:
When securing the oil pump bracket in a vice,
hold the oil pump bracket with the least possi-
ble force between two pieces of wood.
8) Remove the bolt from the rear side of oil pump.
PS-00125
9) Disassemble the oil pump and bracket by insert-
ing a flat tip screwdriver as shown in the figure.
(1)
PS-00434
PS-00188
PS-59
PS-00128
PS-00129