Subaru IMPREZA GD 2007 Series Manual page 2633

asieps_tobira_IM_US.book 126 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
(2) Set the one-way clutch inner race, and apply
compressed air for checking.
(A)
(A) Apply compressed air.
(B) Low clutch drum
8) Check the low clutch clearance.
(1) Place same thickness shims on both sides
to prevent plate from tilting.
(2) Check the clearance between retaining
plate and low clutch operation.
Initial standard:
0.7 — 1.1 mm (0.028 — 0.043 in)
Limit thickness:
1.6 mm (0.063 in)
(A)
(A) Thickness gauge
(B) Low clutch drum
If the drive plate is not being replaced, do not
adjust.
If the value exceeds the service limits, replace
the drive plate with a new part and make adjust-
ment so that the clearance is within the stan-
dard.
Retaining plate
Part No.
31567AA830
31567AA840
31567AA850
31567AA860
31567AA870
AT Main Case
9) Install the washer to the rear internal gear.
(B)
AT-00274
10) Install the rear internal gear.
11) Install the thrust needle bearing in the correct
direction.
(B)
AT-00283
Thickness mm (in)
3.8 (0.150)
4.0 (0.157)
4.2 (0.165)
4.4 (0.173)
4.6 (0.181)
4AT-126
(A)
(A) Rear internal gear
(B) Washer
(A)
(A) Rear internal gear
(B) Low clutch drum
(A)
(B)
(A) Thrust needle bearing
(B) Low clutch drum
(C) Rear planetary carrier side
(D) Low clutch drum side
(B)
AT-00275
(B)
AT-00276
(C)
(D)
AT-02222