Subaru IMPREZA GD 2007 Series Manual page 2985

asieps_tobira_IM_US.book 80 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
NOTE:
• The adapter plate will be the base point for the
measurement. Use a scraper to remove any gasket
material remaining on the end face.
• During measurement, do not place the height
gauge in the shaded area shown in the figure.
3) Measure the height to the ball bearing end face
(height H).
H
(A) Ball bearing
Main Shaft Assembly
NOTE:
Set the height gauge indicator near the measure-
ment target, and lock dial (1) as shown in the figure.
Turn dial (2), and set the indicator to the end face of
the bearing.
MT-00583 Turn approximately 120° at a time, and measure
the ball bearing in 5 locations. Round off the two
highest and two lowest measurement values. The
remaining center value is used as the measure-
ment value.
4) According to the measurement value, select the
snap ring and washer from the following table.
Snap ring
H: mm (in)
270.83 — 271.40
(10.66 — 10.69)
271.41 — 271.98
(10.69 — 10.71)
(A)
271.99 — 272.56
(10.71 — 10.73)
Washer
H: mm (in)
270.83 — 271.40
(10.66 — 10.69)
271.41 — 271.98
(10.69 — 10.71)
271.99 — 272.56
(10.71 — 10.73)
MT-00955
6MT-80
(2)
(1)
MT-00585
Part No. Thickness: mm (in)
1.65
805072010
(0.065)
1.95
805072011
(0.077)
2.25
805072012
(0.089)
Part No. Thickness: mm (in)
1.6
803067012
(0.063)
1.3
803067011
(0.051)
1.0
803067010
(0.039)