Subaru IMPREZA GD 2007 Series Manual page 3368

asieps_tobira_IM_US.book 44 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Rear Drive Shaft
DRIVE SHAFT SYSTEM
16) Tap the clip with the punch provided at the end
of the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tap to an extent that the boot underneath is not
damaged.
DS-00285
17) Cut off the band with an allowance of about 10
mm (0.39 in) left from the clip and bend this allow-
ance over the clip.
NOTE:
Be careful so that the end of the band is in close
contact with clip.
18) Install EBJ boot in the same manner.
19) Extend and retract the DOJ repeatedly to pro-
vide an equal coating of grease.
E: INSPECTION
Check the removed parts for damage, wear, corro-
sion etc. Repair or replace if defective.
1) DOJ (Double Offset Joint)
Check for seizure, corrosion, damage, wear and
excessive play.
2) EDJ (High-efficiency compact double offset
joint)
Check for seizure, corrosion, damage, wear and
excessive play.
3) Shaft
Check for excessive bending, twisting, damage
and wear.
4) EBJ (High-efficiency compact ball fixed joint)
Check for seizure, corrosion, damage, wear and
excessive play.
5) Boot
Check for wear, warping, breakage and scratches.
6) Grease
Check for discoloration and fluidity.
DS-44