Subaru IMPREZA GD 2007 Series Manual page 2576

asieps_tobira_IM_US.book 69 ページ ２０１２年１月１７日 火曜日 午後３時４８分
25.Torque Converter Clutch As-
sembly
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 4AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter clutch and oil pump
shaft horizontally.
NOTE:
Be sure not to scratch the inside of bushing in oil
pump shaft.
3) Remove the input shaft.
NOTE:
When the torque converter clutch assembly is re-
moved, the input shaft may also come off.
4) Remove the clip from the torque converter
clutch.
Torque Converter Clutch Assembly
B: INSTALLATION
1) Install the clip to the converter case.
2) Install the oil pump shaft to the torque converter
clutch, and then make sure that the clip is secured
on the groove.
3) Insert the input shaft, and check the amount of
protrusion.
NOTE:
Turn the input shaft lightly by hand while inserting.
Normal protrusion amount A:
AT-00113
4) While holding the torque converter clutch as-
sembly by hand, carefully install it to the torque
converter case. Take care not to damage the bush-
ing. Do not allow the oil pump shaft bushing to
touch the starter shaft part of the oil pump cover in-
appropriately.
5) Turn the shaft lightly by hand, and engage with
the splines securely.
Dimension A:
AT-00114
6) Install the transmission assembly to the vehicle.
<Ref. to 4AT-39, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Make sure that the ring gear and protrusion of the
torque converter clutch end are not deformed or
damaged.
4AT-69
AUTOMATIC TRANSMISSION
50 — 55 mm (1.97 — 2.17 in)
A
2.7 — 2.9 mm (0.106 — 0.114 in)
(A)
(A) Dimension A
AT-02384
AT-00311