Subaru IMPREZA GD 2007 Series Manual page 2765

asieps_tobira_IM_US.book 32 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
2) If the full stroke is not within the specified range,
adjust it by loosening the clutch stopper nut (for
models without cruise control) or clutch switch lock
nut (for models with cruise control).
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
3) Loosen the push rod lock nuts.
(D)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
(D) Push rod lock nut
4) Rotate the push rod to adjust.
(1) Make sure that the clutch pedal contacts the
stopper bolt side (for models without cruise con-
trol) or clutch switch side (for models with cruise
control) when the pedal is released.
(2) Make sure that the clutch pedal contacts the
clutch pedal bracket stopper when the clutch
pedal is at the maximum stroke position.
(A)
(B)
(C)
(D)
(A) Clevis hole
(B) Push rod lock nut
(C) In the shorter direction
(D) In the longer direction
(E) Push rod
(F) Clevis
Clutch Pedal
(A)
(B)
CL-00042
(F)
(E)
CL-00080
CL-32
5) Turn the push rod to shorten until a clearance is
gained on the stopper bolt side (for models without
cruise control) or clutch switch side (for models with
cruise control).
• Models without cruise control
(A)
(A) Stopper
(B) Stopper bolt
• Models with cruise control
(B)
(A) Clutch switch
(B) Stopper
6) Turn the push rod to lengthen until the clutch
pedal contacts the stopper bolt (for models without
cruise control) or clutch switch (for models with
cruise control).
7) Turn further in the direction that will shorten the
push rod (arrow direction shown in figure) by 270°.
(A)
(A) Accelerator pedal
(B) Clevis
8) Check that the clevis pin moves smoothly by
moving it in the left and right directions.
(B)
CL-00099
(A)
CL-00100
(B)
CL-00101