Subaru IMPREZA GD 2007 Series Manual page 3023

asieps_tobira_IM_US.book 118 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
3) Use a height gauge to measure "D1" and "D2" as
shown in the figure.
D2
D1
(A) 5th main gear
(B) 6th main gear
(1) Shift the 5th-6th sleeve to the 6th main gear
side, push up on the stopper, and measure
"D2".
(A) 6th main gear
Shifter Fork and Rod
NOTE:
• Set the height gauge indicator near the measure-
ment target, and lock dial (1) as shown in the figure.
Turn dial (2), and set the indicator to the 6th side
end surface of the sleeve.
• The measurement is to be performed with two
persons, while holding the sleeve straight.
• Turn approximately 72° at a time, and measure
the sleeve in 5 locations. Round off the two highest
(B)
and two lowest measurement values. The remain-
ing center value is used as the measurement value.
(A)
(2) Set the height gauge indicator upside down.
MT-00712
(A)
MT-00713
6MT-118
(2)
(1)
(A)
(A) Indicator
MT-00585
MT-00710