Subaru IMPREZA GD 2007 Series Manual page 2887

asieps_tobira_IM_US.book 64 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
10) Install the roller bearing onto drive pinion.
NOTE:
When installing the roller bearing, note its direc-
tions (front and rear) because the knock pin hole of
outer race is offset.
(A) Roller bearing
(B) Knock pin hole
11) Install the washer using ST1, ST2 and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 499277100 BUSHING 1-2 INSTALLER
ST2 499277200 INSTALLER
(A) Washer
12) Install the thrust bearing and needle bearing.
Install the driven shaft assembly.
Drive Pinion Shaft Assembly
(A)
(B)
MT-00260
ST2
ST1
(A)
MT-00261
MT-00262
5MT-64
13) Install the drive pinion collar, needle bearing,
adjusting washer No. 2, thrust bearing, adjusting
washer No. 1 and differential bevel gear sleeve in
this order.
NOTE:
Be careful to install the spacer in the proper direc-
tion.
(A) (B)
(C) (D) (E) (F) (G) (H)
(A) Driven shaft
(B) Drive shaft
(C) Drive pinion collar
(D) Needle bearing (25 × 30 × 20)
(E) Adjusting washer No. 2 (25 × 36 × 4)
(F) Thrust bearing (25 × 37.5 × 3)
(G) Adjusting washer No. 1 (25 × 36 × t)
(H) Differential bevel gear sleeve
14) Adjust the thrust bearing preload. <Ref. to
5MT-66, THRUST BEARING PRELOAD, AD-
JUSTMENT, Drive Pinion Shaft Assembly.>
MT-00263