Subaru IMPREZA GD 2007 Series Manual page 2595

asieps_tobira_IM_US.book 88 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
34.Converter Case
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 4AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter clutch assembly.
<Ref. to 4AT-69, REMOVAL, Torque Converter
Clutch Assembly.>
3) Remove the input shaft.
4) Lift up the lever on the rear side of connector,
and then disconnect it from the stay.
5) Disconnect the inhibitor switch connector from
the stay.
(B)
(A) Transmission harness
(B) Inhibitor switch harness
6) Remove the oil charge pipe. <Ref. to 4AT-68,
REMOVAL, Oil Charge Pipe.>
7) Remove the oil cooler inlet and outlet pipes.
<Ref. to 4AT-65, REMOVAL, ATF Cooler Pipe and
Hose.>
8) Remove the converter case alignment bolt, and
then separate the transmission case and converter
case by lightly tapping with a plastic hammer.
Converter Case
NOTE:
• Be careful not to damage the oil seal and bush-
ing in the converter case with the oil pump cover.
• Be careful not to loosen the rubber seal.
9) Remove the seal pipe.
AT-00114
(A)
10) Remove the differential assembly. <Ref. to
4AT-102, REMOVAL, Front Differential Assem-
bly.>
11) Remove the oil seal from converter case.
B: INSTALLATION
1) Check the appearance of each component and
AT-01351
clean them.
2) Press-fit the oil seal to converter case using ST.
ST 398437700
3) Install the differential assembly to the case.
<Ref. to 4AT-102, INSTALLATION, Front Differen-
tial Assembly.>
4) Install the right and left side retainers. <Ref. to
4AT-106, ADJUSTMENT, Front Differential As-
sembly.>
4AT-88
(A) Seal pipe
DRIFT
AT-02386
AT-00176
AT-00177