Subaru IMPREZA GD 2007 Series Manual page 2755

asieps_tobira_IM_US.book 22 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
• Before installing the operating cylinder, apply
grease (KOPR-KOTE: Part No. 003603001) to the
contact point of the release lever and operating cyl-
inder.
• For turbo model, bleed air with the operating cyl-
inder installed to the clutch hose and install the op-
erating cylinder to the body. <Ref. to CL-29, STI
MODEL, PROCEDURE, Clutch Fluid Air Bleed-
ing.>
• Non-turbo model
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
T1
• Turbo model
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
T2
T2
Operating Cylinder
T2
T2
CL-00359
T1
CL-00463
CL-22
• STI model
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
T2: 41 N·m (4.2 kgf-m, 30.2 ft-lb)
T2
NOTE:
• Be sure to install the clutch hose with the mark
side facing upward.
• Be careful not to twist the clutch hose during in-
stallation.
(C)
(A) Mark
(B) Clutch hose
(C) Operating cylinder
2) After bleeding air from the operating cylinder,
ensure that the clutch operates properly. <Ref. to
CL-28, Clutch Fluid Air Bleeding.>
T1
CL-00421
(A)
(B)
CL-00041