Subaru IMPREZA GD 2007 Series Manual page 2879

asieps_tobira_IM_US.book 56 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
2) Install the 3rd drive gear, outer baulk ring, syn-
chro cone, inner baulk ring, sleeve & hub assembly
for the 3rd needle bearing, on the transmission
main shaft.
NOTE:
Align the groove in baulk ring with the shifting in-
sert.
(A) (D)
(B) (C)
(A) 3rd needle bearing
(B) 3rd drive gear
(C) Inner baulk ring
(D) Synchro cone
(E) Outer baulk ring
(F) Sleeve & hub ASSY
3) Install the 4th needle bearing race onto trans-
mission main shaft using ST1, ST2 and press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
(A)
ST1
(A) 4th needle bearing race
Main Shaft Assembly
(E)
(F)
MT-01318
MT-00192
5MT-56
4) Install the baulk ring, needle bearing, 4th drive
gear and 4th gear thrust washer to the transmission
main shaft.
NOTE:
Align the baulk ring and gear & hub assembly with
the key groove.
(B)
(A) Groove
(B) Face this surface to the 4th gear side.
5) Press-fit the ball bearing into the rear section of
transmission main shaft using ST1, ST2 and a
press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A)
MT-00193
ST2
ST1
MT-00194