Subaru IMPREZA GD 2007 Series Manual page 2854

asieps_tobira_IM_US.book 31 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4. Transmission Mounting
System
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air intake duct and air cleaner case.
(Non-turbo model) <Ref. to IN(H4SO)-7, REMOV-
AL, Air Intake Duct.> and <Ref. to IN(H4SO)-5, RE-
MOVAL, Air Cleaner Case.>
3) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, REMOVAL, Intercooler.>
4) Remove the throttle body.
• Non-turbo model
<Ref. to FU(H4SO)-12, REMOVAL, Throttle
Body.>
• Turbo model
<Ref. to FU(H4DOTC)-16, REMOVAL, Throttle
Body.>
5) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION
RUBBER
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the front and center exhaust pipes.
(Non-turbo model)
<Ref. to EX(H4SO)-4, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-7, REMOVAL, Center
Exhaust Pipe.>
4) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, REMOVAL, Center Ex-
haust Pipe.>
5) Remove the rear exhaust pipe and muffler.
• Non-turbo model
<Ref. to EX(H4SO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-9, REMOVAL, Muffler.>
• Turbo model
<Ref. to EX(H4DOTC)-15, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, REMOV-
AL, Muffler.>
Transmission Mounting System
6) Set the transmission jack under the transmission
body.
CAUTION:
Always support the transmission case with a
transmission jack.
7) Remove the front crossmember and rear cross-
member.
8) Remove the transmission cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
MT-00069
2) Install the throttle body.
• Non-turbo model
<Ref. to FU(H4SO)-12, INSTALLATION, Throttle
Body.>
• Turbo model
<Ref. to FU(H4DOTC)-16, INSTALLATION, Throt-
tle Body.>
3) Install the air intake duct and air cleaner case.
(Non-turbo model)
<Ref. to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.> <Ref. to IN(H4SO)-7, INSTALLATION, Air
Intake Duct.>
4) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-14, INSTALLATION, Inter-
cooler.>
5) Connect the ground cable to battery.
5MT-31
MANUAL TRANSMISSION AND DIFFERENTIAL
T2
MT-00079
T1
MT-00085