Subaru IMPREZA GD 2007 Series Manual page 2848

asieps_tobira_IM_US.book 25 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3. Manual Transmission
Assembly
A: REMOVAL
1) Set the vehicle on a lift.
2) Open the front hood fully, and support with stay.
3) Disconnect the ground cable from battery.
4) Remove the air intake duct and air cleaner case.
(Non-turbo model) <Ref. to IN(H4SO)-7, REMOV-
AL, Air Intake Duct.> <Ref. to IN(H4SO)-5, RE-
MOVAL, Air Cleaner Case.>
5) Remove the air cleaner case stay. (Non-turbo
model)
6) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, REMOVAL, Intercooler.>
7) Disconnect the connectors listed below.
(1) Neutral position switch connector
(2) Back-up light switch connector
(3) Vehicle Speed Sensor
8) Remove the starter. <Ref. to SC(H4SO)-8, RE-
MOVAL, Starter.>
Manual Transmission Assembly
9) Remove the operating cylinder from the trans-
mission, and suspend on a wire.
• Non-turbo model
• Turbo model
SC-00176
10) Remove the throttle body.
• Non-turbo model
<Ref. to FU(H4SO)-12, REMOVAL, Throttle Body.>
• Turbo model
<Ref. to FU(H4DOTC)-16, REMOVAL, Throttle
Body.>
11) Remove the pitching stopper.
MT-00065
12) Set the ST.
ST 41099AC000 ENGINE SUPPORT BRACKET
5MT-25
MANUAL TRANSMISSION AND DIFFERENTIAL
ST
MT-01214
MT-01444
MT-00069
MT-01226