Subaru IMPREZA GD 2007 Series Manual page 2475

asieps_tobira_IM_US.book 74 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MECHANICAL
B: INSTALLATION
(1)
(3)
(1) Crankshaft bearing
(2) Crankshaft
(3) Cylinder block
1) Remove oil on the mating surface of cylinder
block before installation. Apply a coat of engine oil
to the bearing and crankshaft journal.
2) Position the crankshaft and O-ring on the cylin-
der block (RH).
3) Apply liquid gasket to the mating surfaces of cylin-
der block (RH), and position the cylinder block (LH).
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
NOTE:
Do not allow liquid gasket to run over into O-ring
grooves, oil passages, bearing grooves, etc.
Cylinder Block
(5)
(4)
(7)
(6)
(6)
(4) Rear oil seal
(5) O-ring
ME-00145
ME(H4DOTC)-74
(3)
(2)
(6) Seal washer
(7) Washer
4) Apply a coat of engine oil to the washer and bolt
thread.
NOTE:
Use a new seal washer.
5) Tighten the 10 mm cylinder block connecting
bolts on LH side (A — D) in alphabetical sequence.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
(A)
(D)
(B)
(C)
(6)
(7)
ME-03207
ME-00779