Subaru IMPREZA GD 2007 Series Manual page 2958

asieps_tobira_IM_US.book 53 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7) Match the hole of the reverse check lever and
the reverse check shaft, and attach the spring pin.
(C)
(A)
(A) Reverse check shaft
(B) Reverse check lever
(C) Hole
8) Check that the reverse check is operating cor-
rectly. <Ref. to 6MT-53, INSPECTION, Reverse
Check System.>
9) Install the extension case. <Ref. to 6MT-44, IN-
STALLATION, Extension Case.>
10) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
Reverse Check System
(B)
MT-00502
6MT-53
MANUAL TRANSMISSION AND DIFFERENTIAL
C: INSPECTION
1) Check that there is no damage on each part.
2) Check that the reverse check lever is operating
smoothly.
3) Inspect that there is no oil leak at the oil seal sec-
tion of the reverse check shaft. If there is oil leak-
age, replace the oil seal.
4) Check the operation of the reverse check.
(1) When the reverse check lever is in the fol-
lowing position, the plunger is pressed, or the
gear can shift into reverse.
(2) When the reverse check lever is in the fol-
lowing position, the plunger is not pressed, or
the gear cannot shift into reverse.
5) If not according to the standard, reassemble the
reverse check system.
MT-00503
MT-00504