Subaru IMPREZA GD 2007 Series Manual page 2583

asieps_tobira_IM_US.book 76 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
5) Install the snap ring to the ST.
ST 499257300 SNAP RING OUTER GUIDE
(A)
(B)
(A) Snap ring
(B) Transfer clutch
6) Install the snap ring to the rear drive shaft using
ST1 and ST2.
ST1 499257300 SNAP RING OUTER GUIDE
ST2 499247400 INSTALLER
(A)
(A) Snap ring
(B) Transfer clutch
7) Install the driven plate, drive plate, pressure
plate and snap ring.
(A)
(A) Snap ring
Transfer Clutch
8) Apply compressed air to see if the assembled
parts move smoothly.
ST
AT-00136
9) Check clearance between the snap ring and
pressure gauge. <Ref. to 4AT-77, INSPECTION,
Transfer Clutch.>
10) Press-fit new ball bearing using ST.
ST 899580100
ST2
ST1
(B)
(A) Ball bearing
AT-00137
11) Apply Vaseline to a new seal ring and attach to
the seal ring groove of the shaft.
NOTE:
While installing the seal ring, not to stretch the seal
ring excessively.
AT-00138
(A) Seal ring
(B) Transfer clutch
4AT-76
AT-00139
INSTALLER
ST
(A)
AT-00140
(B)
(A)
AT-00141